Well, OK, not the whole enclosure, just the parts that hold it together.
MegaMax can print big stuff but he’s had problems with large prints delaminating. The answer seems to be enclosing the printer to keep the prints warm while printing. I designed this box and 3D printable parts to hold it together so that I can take the box apart easily to work on MegaMax or move him to other locations and put it back together when I’m done. The box is 38″ D x 28″ H x 32″ W.
The box is made of 1″ PIR foam with corners suitably notched to accommodate the printed parts. MegaMax has a 450 Watt heater in the printbed so the box gets super-toasty inside. I suspect it gets a little too toasty but haven’t made any measurements yet. I’ll soon be moving the electronics out of the box. I didn’t do anything to seal the seams in the box because it doesn’t seem to be necessary. I did tape the edges of some of the foam boards with clear packing tape to prevent damage.
Design and stl files are available at http://www.thingiverse.com/thing:269586