Plate & Print

Plate & Print

Remember my post about making printing plates? I finally got a chance to try it out.

I took a sheet of 3mm Baltic Birch plywood and etched it with the 25 watt laser cutter. My design was about 5 inches wide by 6 1/2 inches tall and took about 90 minutes to complete. I etched it at 100% speed / 60% power. (Shane’s etching chart was quite helpful.)

Once the plate was done I had to head out, so I didn’t get to use the press we have, so I ended up just doing a quick test at home and hand burnishing the print, so it doesn’t exactly look great… but this was just a test. Rolling the ink onto the plate worked well, the etching was deep enough to keep the ink out.

I look forward to the next step in this process, trying this print in the real press and seeing how it turns out. I’m also still learning about the sort of paper I should use. The stuff I have now is “fine” and a bit thin. I did get some advice from jason g. who said “Two words: Rives BFK” and that’s all he had to say about that. :)

Oh, and I almost forgot to reverse my artwork before I etched it! Not good… As for the robot, it’s one I drew last year.