Camera Accessory Mounting System

CAMS pieces

Those who know me know that besides being cheap (hey, it’s part of being a maker and being DIY) I tend to use cameras a lot. Well, on occasion camera related things break, or I’ll need a part that doesn’t exist yet, or exists, but it too expensive, or isn’t designed right, or whatever.

All of the issues mentioned above lead me to create “CAMS” the “Camera Accessory Mounting System”, which will be a modular system that allows me to mount things to cameras, and mount cameras to things.

The connecting pieces of CAMS are 3D printed, and design is happening in OpenSCAD. The other parts of CAMS consists of standard 1/4″ hardware, nuts, bolts, screws, etc. There are also knobs that fit onto the nuts to allow for easy finger tightening.

CAMS Arm

There’s a wiki page for CAMS, which doesn’t have a ton of info yet, but you can also check out blog post #1 and blog post #2 about the arm.

Leave a Reply

Your email address will not be published. Required fields are marked *